car GAZ-2705
The hydraulic pushers of the ZMZ-406, ZMZ-405 engines, made in the form of cylindrical pushers and located between the cam shaft and the valves, combine two functions: transmitting force from the cam shaft to the valves and eliminating gaps in their drive.
The cylinder head can be removed with the intake pipe and exhaust manifold. If the cylinder head is removed from an engine installed on a car, you must first perform the following operations:
- - drain the liquid from the cooling system;
Adjusting the bearing clearance of the rear hub of the GAZ-2705
To adjust the bearings you need:
Setting the ignition timing of a GAZ-2705 with a 402 engine
The ZMZ-402 engine is equipped with an ignition distributor sensor (1908.3706) - non-contact, with a control pulse sensor (generator) and built-in vacuum and centrifugal ignition timing regulators
The intake system consists of an intake pipe and a receiver cast from aluminum alloy
The geometric parameters of the system make it possible to implement gas-dynamic supercharging of the engine - improving the filling of the engine cylinders at a certain operating mode
The engine must be thoroughly cleaned of dirt before disassembly
