In the fuel injection engine power system, the pressure is 30 MPa (3 kgf/cm 2).
Therefore, it is forbidden to loosen the connections of the fuel lines while the engine is running or immediately after stopping it
Repair of ignition distributor GAZ-2705
Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke
On cars with a ZMZ-406 engine, a starter 42.3708-10 is installed on the clutch housing on the right side, and with a ZMZ-402 engine - ST230-B4 - on the left side of the clutch housing
The front axle is removed from the car in the following sequence:
- - loosen the wheel nuts
Main brake cylinder GAZ-2705 removal and repair
The main brake cylinder with two successive pistons 10 and 17 and a two-section reservoir 4 with sensor 6 for an emergency brake fluid level drop indicator is attached to the cover of the vacuum booster
Removing the window regulator
Remove the door trim (see the article - “How to remove the trim and front door lock of a Gazelle car”)
The rear suspension is made on two longitudinal leaf springs with two hydraulic shock absorbers