Checking the technical condition of the timing drive

Remove the top cover.

Check the timing belt (A) for damage, oil or coolant ingress

The cylinder head can be removed with the intake pipe and exhaust manifold. If the cylinder head is removed from an engine installed on a car, you must first perform the following operations:

  • - drain the liquid from the cooling system;

The fuel supply system filters the fuel and distributes it evenly among the engine cylinders in metered portions at strictly defined moments

Cylinder block

The ignition system - battery-operated, contactless - consists of an ignition coil, a switch, an ignition distributor sensor, spark plugs, spark plug tips, low and high voltage wires. The ignition system diagram is shown in the car electrical equipment diagram

Installing cylinder heads, valve rocker arms and adjusting valve clearances

The cylinder head mounting studs are screwed into the right and left rows of the cylinder block, having previously lubricated the threaded holes for the studs in the block with diesel oil

Page 4 of 5