Hydraulic drive pressure regulator on vehicles with split drive on the sides

The hydraulic drive brake force regulator is designed to adjust the brake fluid pressure when braking the vehicle, in order to prevent the rear wheels from locking when the vehicle is partially loaded

A two-section brake valve is used to control the actuators of the vehicle's service brake system.

A two-section brake valve is installed on the front shield of the cabin.

The figure shows the installation locations of the parts and their designations according to the spare parts catalog.

We look at the figure and the table shows the decoding of the part.

The figure shows the installation locations of the parts and their designations according to the spare parts catalog.

We look at the figure and the table shows the decoding of the part.

There are two pistons in the ZIL-5301 wheel cylinder housing, which are expanded by a spring with support cups.

The same spring presses the seals (cuffs) to the end of the pistons.