Installation of air cylinders ZIL-5301 according to the catalog

The figure shows the installation locations of the parts and their designations according to the spare parts catalog

Signaling device for a car with a brake drive divided on the sides

The device is located on the bracket of the left mudguard of the wing

Clutch (parts catalog) ZIL-5301

The clutch housing is steel, attached to the flywheel with bolts. The pressure plate is made of grey cast iron and is attached to the casing with four pairs of spring plates that transmit torque from the casing to the pressure plate.

The figure shows the installation locations of the parts and their designations according to the spare parts catalog.

Only clean, filtered oil specified in the lubrication chart should be poured into the power steering reservoir.

A paper filter is installed in the pump reservoir

The filter must be replaced every 40 thousand km.

The compressor is designed to compress air and then pump it into the pneumatic system.

The compressor is installed on the left side of the engine timing gear cover.

The ZIL-5301 oil-moisture separator is installed on the frame together with the pressure regulator and serves to clean the pneumatic brake system from emulsion

The figure shows the installation locations of the parts and their designations according to the spare parts catalog.