Problems with starting a car engine can be divided into two main groups depending on the degree of engine heating
Signs of a faulty pressure regulator may be:
- – unstable engine operation;
The ignition module is installed on the engine cylinder block on the left side. A faulty module cannot be repaired and must be replaced
Removing the front mudguards
To protect the front wheel wells of the car from dirt, plastic mudguards consisting of two parts are installed
The transfer case is designed to change the torque in magnitude and distribute it between the front and rear drive axles
Carry out all checks and work from underneath the vehicle, installed on a lift or inspection pit (with the front wheels raised)
We remove the steering wheel when removing the steering column and for other repair work
The controller is the central device of the engine management system
If you hear knocking sounds in the front drive when turning the car while driving, check the constant velocity joints
Each diagnostic chart consists of two pages: "Additional information" and "Troubleshooting chart"
The diagram of the rear window heating system is shown in Fig. 1.
If the engine cylinder head installed on the vehicle needs repair, remove it as described in the article "Replacing the Niva Chevrolet Cylinder Head Gasket"
To disassemble, remove the gearbox from the car for this:
Prepare the car and disconnect the negative terminal of the battery
The airbag control unit circuit has an emergency power reserve
To check the compression, it is recommended to use compression testers for gasoline engines of the G-324 type by Triscko Taiwan or KA – 6721K by KT TOOLS Taiwan
We remove the engine cooling radiator for replacement if a leak appears from the tanks or radiator cells, as well as during repair work related to access to engine components and parts.
A malfunction associated with loss of idle speed is mainly associated with a failure of the idle speed control valve
