Prepare the car for work. Disconnect the negative battery terminal.
Open the rear doors of the car.
The compressor pulley is mounted on a double-row ball bearing.
When pressing out, the bearing is destroyed, so we press it out only for replacement
We check the instrument cluster when replacing or repairing the instrument cluster, as well as when removing the instrument panel
This article describes the diagnostic procedure used for the electronic control unit (ECU) EMS 31.32 of the electronic engine management system (ESM) K7M and K4M
Troubleshooting Codes Table
Code - Description
- DF001 Coolant Temperature Sensor Circuit
The brake pads must be replaced as a set
Prepare the car for the work.
We are replacing the gasket due to its burnout
Installing pistons with connecting rods
Lubricate the upper parts of the cylinders and the connecting rod journals of the crankshaft with engine oil.
We remove the front suspension arms for replacement or repair. Damage to the arm can be:
Interpretation of conditions
ET018 - Request to turn on the air conditioner
Diagnostic instructions
Prepare the car for work. Disconnect the negative battery terminal.
Perform the work on a lift or inspection pit.
We remove and replace the supports if they are defective or when repairing the power unit
Preparing the car for work
Remove the power steering pump for replacement, as well as when dismantling the engine
Cars not equipped with ABS have a rear brake pressure regulator
Most electrical circuits are protected by fuses. Powerful consumers are connected via relays
In this article we will consider the removal and installation of tubes connecting the entire air conditioning system of the Lada Largus
