Removing and disassembling the GAZ-3110 wiper

Disconnect the wire from the "negative" terminal of the battery.

Pull off both levers with pliers

Raise the caps. Unscrew not completely (so as not to spoil the threads on the rollers) the nuts securing the wiper arms.

Using pliers, pull both wiper arms off the splines of the wiper mechanism rollers and, finally unscrewing the nuts, remove the arms.

Remove the four bolts securing the lower front panel.Raise the front part lower front panel and move panel forward

Remove the four bolts securing the lower bulkhead panel.

Lift the front of the lower bulkhead panel and slide the panel forward, disengaging the grooves from the mounting studs.

Disconnect block 1 with wires from the holder and disconnect it

Disconnect block 1 with wires from the holder and disconnect it.

Disconnect the washer hose from the tee.

Remove the lower front panel along with the wiper assembly.

Отвернуть по два болта 1 крепления валиков рычагов Отвернуть гайку 1 и снять поводок 2 с вала редуктора.

Remove two bolts 1 securing the wiper arm rollers on both sides, four bolts 2 securing the wiper arm and remove the wiper assembly.

Unscrew nut 1 and remove driver 2 from the gear shaft

Отвернуть три винта 1, два винта 2 и снять электродвигатель

Unscrew three screws 1, two screws 2 and remove the electric motor with the gearbox from the bracket

Assemble the windshield wiper in the reverse order of disassembly.

Lock the driver fastening nut on the gearbox shaft with paint.

Рычаги стеклоочистителя установить так, чтобы  щетки в состоянии покоя находились от нижнего уплотнителя на расстоянии 10–15 мм.

Install the wiper in the reverse order of removal.

Install the wiper arms so that the brushes at rest are at a distance of 10-15 mm from the lower seal.

электрическая схема стеклоочистителей ГАЗ-3110

Wiper Wiring Diagram

Select your language