Turn off the ignition, disconnect the "negative" terminal of the battery
Disconnect the throttle position sensor connector
Using a screwdriver, we loosen the clamp of the air supply hose to the throttle body and remove the hose.
Disconnect the throttle cable (see Replacing the gas cable GAZ-3110).
Drain the coolant (see Replacing the GAZ-3110 coolant)
Loosen the clamps of the coolant supply hoses with a screwdriver
Remove the hoses
Using a screwdriver, we loosen the hose clamps of the idle speed regulator, crankcase ventilation and remove the hoses from the nozzles of the throttle body
Using a 6 hex wrench, unscrew the four bolts securing the throttle pipe to the receiver
Carefully, so as not to damage the gasket, remove the throttle body
Install the throttle body in reverse order. After installation, you need to adjust the throttle actuator.