We replace the throttle control cable if it is broken or difficult to move
Disconnect the wire from the negative terminal of the battery.
Unscrew nut 1 and remove accelerator cable 2 from sector 3 of the air throttle valve drive.
Move the oil seal 1 from the cable tip, completely unscrew the nut 2 from the cable tip, pull out the cable shell tip 3 from the bracket and lift the cable up from the bracket through the slot.
Remove tip 3 from the cable by removing it from the outer 4 and inner sheaths of the cable.
Remove the outer 1 and inner sheaths of the cable from the tip 2 on the front panel
Remove cotter pin 1 from pin and remove pin 2. Move oil seal 4 and remove bracket 3
Pull the cable through the end on the front panel into the passenger compartment.
Install the new accelerator cable in reverse order and adjust it
Adjusting the accelerator cable
Loosen the tightening of nut 1 securing cable 2 on sector 3.
Loosen the tightening of nut 2 of adjusting bolt 1 between the upper 4 and lower 3 levers of the accelerator pedal.
From sector 3 of the throttle valve, pull out cable 1 until it stops.
In this case, the upper lever 5 of the accelerator pedal should rest against the buffer 4 on the bracket.
Tighten nut 2 securing the cable to the sector.
In this case, the throttle valve must be completely closed.
Pull the upper lever of the 4th pedal towards you until it stops.
In this case, the throttle valve must be fully open.
Holding the upper pedal lever 4 in this position, turn the lower pedal lever 3 until it stops on the mat and tighten the nut 2 of the adjusting bolt 1
For correct adjustment, when the pedal is fully released, the throttle valve should be completely closed and the upper pedal arm should rest against the buffer on the bracket.
When the pedal is fully depressed, the throttle valve should be fully open and the lower pedal arm should rest against the mat.
You can correct the position of the cable by moving the tip 1 of the shell in the bracket, loosening the nuts 2. After adjusting, tighten the nuts 2.
