Remove the steering knuckle when replacing the hub bearing, repairing the front suspension strut

Prepare the vehicle for work. Disconnect the negative terminal of the battery.

Preparing the car for work

Remove the oxygen sensors if they fail and when dismantling the exhaust pipes

Lada Largus cars are equipped with a steering system with a rack and pinion type steering mechanism and a hydraulic booster

Engine removal was discussed in the article - "Removing the K7M engine"

Place the trolley with the engine and gearbox assembly under the car, which is raised on a lift.

The design feature of the transmission with the JH3 gearbox is the approximation of equal length of the drives

The heating (air conditioning) and ventilation system is a single complex that provides the most comfortable conditions in the car regardless of weather conditions and driving mode

Removing the engine was discussed in the article - "How to remove the K4M engine from a Lada Largus car"

We remove the front wheel drives to replace the drive covers. We also remove them when replacing the drive seals and when dismantling the gearbox.

Preparing the car for work

Work is performed on an inspection pit or on a lift

The condenser (air conditioner radiator) is a multi-flow type and is installed in front of the engine cooling system radiator

The condenser is attached to the cooling system radiator tanks with four brackets

The clutch of the Lada Largus car is single-plate, dry type

The evaporator is removed for replacement in case of malfunction.

The evaporator is installed in the heating and air conditioning system unit of the passenger compartment.

It is advisable to check the fluid level in the expansion tank of the cooling system during each inspection of the car before leaving and necessarily in the event of engine overheating and the associated release of fluid from the system