car GAZ-3110
Disassembly and assembly of the input shaft of the GAZ-3110 gearbox
Remove the locking ring if it remains on the input shaft.
Replacing the turn signal lamp
Disconnect the wire from the negative terminal of the battery
Removal and installation of rear shock absorber GAZ-3110
The main reasons for replacing shock absorbers are ineffective damping of vibrations, knocking in the suspension, leakage of shock absorber fluid
Removing and installing the rear suspension spring of GAZ-3110
Disconnect the lower shock absorber mounting.
Unload the spring and install a stop under the rear axle.
We remove the spark plug tips along with the high-voltage wires, the ignition coils (you can only disconnect the connectors, leaving them on the valve cover), the throttle drive cable and, having disconnected the wires from the lubrication and cooling system sensors, remove the wiring harness from the head cover brackets
We remove the generator for inspection and repair
The master cylinder must be repaired or replaced when the pressure in the clutch release drive is not maintained (when pressed smoothly, the pedal reaches the stop, but the clutch does not disengage)
