Turn off the ignition and disconnect the engine control system wiring harness block from the coil
We carry out the work in an inspection pit or on a lift
From the bottom of the car, using a 13 mm spanner, loosen the tightening of the nut of the coupling bolt of the clamp securing the control rod to the shank of the gear selector rod hinge (Fig. 1)
Some drivers, trying to wear out the parking brake cable less, try to use it less often
- Replacing the front strut of a Lada Kalina car
- Replacement of steering rods and ends of a Lada Kalina car
- Lada Kalina car starter repair
- How to replace the tension roller of a Lada Kalina generator
- Repair of the front wheel brake mechanism of Lada Kalina
- Lada Kalina rear door repair
- Features of the Lada Kalina gearbox