car GAZ-2705
Adjusting the position of the steering column must be done after adjusting the driver's seat relative to the control pedals. To do this you need:
Electromagnetic injector (0280150560B or ZMZ DEKA IA9Z61) – an electromechanical valve operating on the principle of an electromagnet
The ignition system - battery-operated, contactless - consists of an ignition coil, a switch, an ignition distributor sensor, spark plugs, spark plug tips, low and high voltage wires. The ignition system diagram is shown in the car electrical equipment diagram
The cylinder head can be removed with the intake pipe and exhaust manifold. If the cylinder head is removed from an engine installed on a car, you must first perform the following operations:
- - drain the liquid from the cooling system;
Checking the wear of the king pin and bushings
We carry out the check with the front wheel hub bearings adjusted.
We discussed dismantling the axle gearbox in the article - How to disassemble the rear axle of a Gazelle car
In this article we will look at how to properly assemble and adjust the rear axle gearbox of a Gazelle car.
Reducing pressure in the power system
Remove the fuel pump fuse from the fuse box
