engines

Synchronization sensor - inductive type (2612.1.113 Bosch or 406.3847113) is installed on the front end of the engine at the bottom, on the right side and is designed to synchronize the operation of the control unit with the engine workflow

Replacing the cylinder head cover gasket ZMZ-406

Over time, during operation, the gasket under the engine head cover loses its elasticity and strength and oil leaks from under the cover

Before installing the demultiplier with a spacer on the crankcase of the main box and the spacer on the crankcase of the demultiplier, apply the anaerobic sealing compound UG-6 TU 6-01-1285-84 to the gaskets on both sides with a continuous strip 2-3 mm wide along the contour

If there is a loss of power, increased fuel consumption or increased oil consumption, it is necessary to check the compression in the engine cylinders

Oil pump - gear type, with internal gears and pressure reducing valve

Page 23 of 23

New

Gearbox input shaft Kamaz

Input shaft 13 is mounted on two ball bearings.

The front bearing of the input shaft with a cuff is located in the crankshaft socket, the rear bearing is located in the bore of the front end of the gearbox housing

Setting the TDC of the VAZ-21126 engine

The piston of the 1st cylinder is set to the TDC (top dead center) position of the compression stroke so that when carrying out work related to the removal of the camshaft drive belt, the valve timing is not disturbed