We remove the rear wheel axles to replace or adjust the rear axle gearbox or to remove the rear wheel hubs

Removing the rear wheels

Removing the rear wheels and axle shafts of a Gazelle carRemoving the rear wheels and axle shafts of the Gazelle car

With a "balloon" wrench (head "27") loosen the six wheel nuts.

We raise and hang the rear axle with a jack on one side. Loosen the wheel nuts completely. Under one of the nuts there is a plate for fastening the nipple of the "inner" wheel.

Removing the rear wheels and axle shafts of a Gazelle carRemoving the rear wheels and axle shafts of the Gazelle car

Remove the "outer" wheel

Removing the "inner" wheel

Install the wheels in reverse order, lubricating the studs with graphite grease.

Tightening torque for wheel nuts 30 - 38 kgcm.

You can not put different sizes of rear wheels.

Removing the axle shaft

Removing the rear wheels and axle shafts of a Gazelle carRemoving the rear wheels and axle shafts of a Gazelle car

Using the “19” head, unscrew the eight nuts securing the axle shaft to the rear wheel hub.

Substituting a small container for oil into the wheel, we pull it off the studs with our hands or with a special drift

Removing the rear wheels and axle shafts of the Gazelle carRemoving the rear wheels and axle shafts of a Gazelle car

Remove the half shaft from the bridge

Remove the cardboard spacer from the studs

If there is no drift, and it is not possible to remove the axle shaft with your hands, you can knock it out with a hammer through the beard, having previously removed the outer wheel for convenience.

We install the axle shaft in the reverse order, after which we fill the wheel hub with oil.