The ignition module is installed on the engine cylinder block on the left side. A faulty module cannot be repaired and must be replaced
You will need: a 10 mm spanner and a screwdriver.
Remove the high-voltage wire tips from the module sockets.
Using a screwdriver or your finger, press the plastic retainer and disconnect the wiring harness connector from the module.
Using a 5 mm Allen key, unscrew the four screws securing the coil to the bracket
Removing the ignition module
Install the module in the reverse order of removal.
Attach the wiring harness block to the module and insert the high-voltage wire tips into the sockets.
The high-voltage wires and the module body are marked with the numbers of the corresponding cylinders.
